Alunite micronizer

  Alunite is a sulfate mineral that was first observed in north of Rome, where it was mined for the manufacture of alum.
Distinct crystals of alunite are rarely found in cavities in the massive material. Alunite varies in color from white to yellow gray. The hardness is 4 and the specific gravity is between 2.6 and 2.8. The mineral is a hydrated aluminium potassium sulfate, KAl3(SO4)2(OH)6. Sodium substitutes for potassium and when high in sodium it is called natroalunite. It is insoluble in water or weak acids, but soluble in sulfuric acid.
  Alunite  micronizer is professionally processing fine and superfine powder of non-inflammable, non-explosive and brittle materials with Moh's hardness under six, the moisture under 5% such as calcite, chalk, limestone, dolomite, kaolin, bentonite, talc, mica, magnesite, illite, pyrophyllite and vermiculite, sepiolite, attapulgite, rectorite, diatomite, barite, gypsum, alunite, graphite, fluorite, rock phosphate, Kalium ore, pumice, etc., totally more than 100 kinds of materials.
Finished  Alunite  powder fineness: 47-5 micron (325mesh-2500mesh)
Capacity: 0.4-12T per hour
 
Models  Alunite  Micronizer: HGM80/HGM90/HGM100/HGM100A/HGM125
Working principle:
1) After crushed by hammer crusher, the large materials become smaller pieces and are sent to the micro powder grinding mill.
2) When the micro powder grinding mill is at work, the granulated materials are crushed and grinded by the rollers into particles below 47micron.
3) The high-pressure air blower constantly inhales air within the micro powder grinding mill.
4) Along with the high speed airflow, micronized materials are brought to the classifier.
5) The qualified particles are screened and driven into the cyclone powder collector, finally exit from the discharging valve at the bottom;
6) A small proportion of the fine powders, with airflow, moving to the dust cleaner. Filtered clean air will be emitted from the air outlet of muffler in the end.


Technical data of   Alunite Micronizer:
Model HGM80 HGM90 HGM100 HGM100A HGM125
Ring Diameter(mm) 800 930 1035 1300
Ring Number(PCS) 3 3~4 3 4 4
Roller Number(PCS) 21 24~32 27 34~36 40~44
Main Shaft Speed(r.p.m.) 230~240 200~220 180~200 135~155
Input Size(mm) ≤20
Finished Size/um(mesh) 5-47(325~2500)
Capacity (t/h) 0.5-4.5 0.6-6.5 0.7-7 1-8.5 1.5-12
Outlet Size (L*W*H, m) 13.9*4*6.2 14.7*4.8*7.2 18*4.6*8.6 14*9*10.25
Motor Power(KW) 145-165 185-204 263 263-290 380-430